A practical reference on photodegradation: what it is, how it behaves, what the literature reports, and where the honest uncertainties sit.
Reviewed 2026-02-08. Anything still debated is marked as such rather than presented as settled.
Light, oxygen, and pH influence peptide integrity through specific side-chain reactions. Methionine and cysteine residues are susceptible to oxidation, and tryptophan can degrade under strong light. Inert gas overlays and amber glass or opaque containers reduce these risks. pH affects charge, solubility, and the rate of deamidation or aggregation; a value that minimizes one pathway may increase another. The optimal pH and buffer for a given peptide are often determined experimentally, and open questions remain about predicting stability from sequence alone.
Peptides are short chains of amino acids linked by amide bonds, and their storage stability depends on sequence, length, and three-dimensional structure. Chemical degradation can occur through hydrolysis, oxidation, deamidation, and aggregation, while physical changes such as precipitation or surface adsorption reduce recovery. Storage conditions are chosen to slow these processes without altering the peptide itself. Because peptides vary widely, no single condition suits every sequence, so laboratories often establish stability empirically for each batch.
Temperature is a primary factor because most degradation reactions proceed more slowly at lower temperatures. Lyophilized peptides are commonly held at -20 °C or below, although some sequences remain stable at 2–8 °C for limited periods. Moisture uptake during handling can accelerate hydrolysis, so sealed containers and desiccants are used. Solutions are generally less stable than powders and may require freezing at -80 °C or refrigeration, depending on the peptide. Repeated freeze-thaw cycles can promote aggregation even when the storage temperature is otherwise suitable.
Reconstitution is often performed with sterile water, buffer, or a water-miscible organic solvent, depending on solubility. The solvent should be added gently along the vial wall, and the solution mixed by gentle swirling rather than vigorous vortexing, which can cause foaming and surface denaturation. Some sequences require a small amount of base or acid to dissolve, followed by pH adjustment. Preparing a concentrated stock solution can simplify later dilution, but the stock itself may have limited stability. Records of solvent, concentration, and date support reproducibility.
After reconstitution, dividing the solution into single-use aliquots limits multiple warming and cooling events and reduces contamination risk. Low-binding polypropylene tubes are often preferred because peptides can adsorb to glass or untreated plastic surfaces. Filling headspace with nitrogen or argon can slow oxidation, and amber or foil-wrapped containers reduce photodegradation. Each aliquot should be labeled with peptide identity, concentration, date, and storage conditions. Frozen aliquots should be thawed quickly and kept on ice until use.
When a peptide arrives, the vial should be inspected for damage, and its label, lot number, and accompanying analytical data should be recorded. Cold vials should equilibrate to room temperature before opening to prevent condensation on the powder. Moisture uptake can reduce stability and complicate accurate weighing or reconstitution. Inventory systems that track date, quantity, and storage location help prevent unnecessary temperature cycling. Personnel should follow institutional or manufacturer instructions for any specific peptide.
| Property | Value | Notes |
|---|---|---|
| Appearance (lyophilized) | White to off-white powder | May appear fluffy, crystalline, or amorphous depending on manufacturing |
| Solubility class | Typically water-soluble | Solubility varies with sequence and pH; some require organic co-solvents |
| Typical storage temperature (lyophilized) | -20 °C or lower | Some peptides tolerate 2–8 °C; moisture control is critical |
| Typical storage temperature (solution) | -80 °C to 2–8 °C | Depends on peptide; avoid repeated freeze-thaw cycles |
| Common analytical method | Reverse-phase HPLC | Used for purity, identity, and degradation monitoring; mass spectrometry often confirms mass |
Development of the long acting insulin NPH in the 1940s by Novo Nordisk Identification of the first of the sulfonylureas in 1942 Reintroduction of the use of biguanides for type 2 diabetes in the late 1950s. The initial phenformin was withdrawn worldwide (in the U.S. in 1977) due to its potential for sometimes fatal lactic acidosis and metformin was first marketed in France in 1979, but not until 1994 in the US. The determination of the amino acid sequence of insulin (by Sir Frederick Sanger, for which he received a Nobel Prize). Insulin was the first protein that the amino acid structure was determined. The radioimmunoassay for insulin, as discovered by Rosalyn Yalow and Solomon Berson (gaining Yalow the 1977 Nobel Prize in Physiology or Medicine) The three-dimensional structure of insulin (PDB: 2INS) Dr Gerald Reaven's identification of the constellation of symptoms now called metabolic syndrome in 1988 Demonstration that intensive glycemic control in type 1 diabetes reduces chronic side effects more as glucose levels approach 'normal' in a large longitudinal study, and also in type 2 diabetics in other large studies Identification of the first thiazolidinedione as an effective insulin sensitizer during the 1990s In 1980, U.S. biotech company Genentech developed biosynthetic human insulin. The insulin was isolated from genetically altered bacteria (the bacteria contain the human gene for synthesizing synthetic human insulin), which produce large quantities of insulin. The purified insulin is distributed to pharmacies for use by diabetes patients.
=== Strain-promoted alkyne-nitrone cycloaddition (SPANC) === Diaryl-strained-cyclooctynes including dibenzylcyclooctyne (DIBO) have also been used to react with 1,3-nitrones in strain-promoted alkyne-nitrone cycloadditions (SPANC) to yield N-alkylated isoxazolines.
=== Anti-histone antibodies === Anti-histone antibodies are found in the serum of up to 75–95% of people with drug-induced lupus and 75% of idiopathic SLE. Unlike anti-dsDNA antibodies in SLE, these antibodies do not fix complement. Although they are most commonly found in drug induced lupus, they are also found in some cases of SLE, scleroderma, rheumatoid arthritis and undifferentiated connective tissue disease. Many drugs are known to cause drug induced lupus and they produce various antigenic targets within the nucleosome that are often cross reactive with several histone proteins and DNA. Procainamide causes a form of drug-induced lupus that produces antibodies to the histone H2A and H2B complex.
Jaundice (yellow skin and/or whites of the eyes) This is where bilirubin deposits in skin, causing an intense itch. Itching is the most common complaint by people who have liver failure. Often this itch cannot be relieved by drugs. Fluid accumulating in the abdomen, and swelling of the ankles and feet occurs because the liver fails to make albumin. Excessive fatigue occurs from a generalized loss of nutrients, minerals and vitamins. Bruising and easy bleeding are other features of liver disease. The liver makes clotting factors, substances which help prevent bleeding. When liver damage occurs, these factors are no longer present and severe bleeding can occur. Pain in the upper right quadrant can result from the stretching of Glisson's capsule in conditions of hepatitis and pre-eclampsia.
Sources: en.wikipedia.org
EosFP is a photoactivatable green to red fluorescent protein. Its green fluorescence (516 nm) switches to red (581 nm) upon UV irradiation of ~390 nm (violet/blue light) due to a photo-induced modification resulting from a break in the peptide backbone near the chromophore. Eos was first discovered as a tetrameric protein in the stony coral Lobophyllia hemprichii. Like other fluorescent proteins, Eos allows for applications such as the tracking of fusion proteins, multicolour labelling and tracking of cell movement. Several variants of Eos have been engineered for use in specific study systems including mEos2, mEos4 and CaMPARI.
== Scientific career before and during World War II == Cremer joined Otto Hahn at Kaiser Wilhelm Institute for Chemistry to study radioactive trace compounds in 1937. She moved labs shortly after to concentrate on isotope separation. In 1938, Cremer received her habilitation from the University of Berlin. In any ordinary case, this qualification would lead to faculty positions; however, the Nazi government of the time had passed the Law on the Legal Position of Female Public Servants. The law banned women from senior positions (e.g. professorship) and required women to quit once married. Many women scientists and scholars were left unemployed or limited in career prospects. After World War II began and male scientists and professors were drafted, Cremer was able to obtain a position as a docent in 1940 at the University of Innsbruck in Austria. However, she was informed that she would leave her job once the war had ended and the men came home. Cremer was pleased with her new position and location because she was able to mountain climb, a hobby of hers.
==== Surveys ==== The World Mental Health survey initiative has suggested a plan for countries to redesign their mental health care systems to best allocate resources. "A first step is documentation of services being used and the extent and nature of unmet treatment needs. A second step could be to do a cross-national comparison of service use and unmet needs in countries with different mental health care systems. Such comparisons can help to uncover optimum financing, national policies, and delivery systems for mental health care." Knowledge of how to provide effective emotional mental health care has become imperative worldwide. Unfortunately, most countries have insufficient data to guide decisions, absent or competing visions for resources, and near-constant pressures to cut insurance and entitlements. WMH surveys were done in Africa (Nigeria, South Africa), the Americas (Colombia, Mexico, United States), Asia and the Pacific (Japan, New Zealand, Beijing and Shanghai in China), Europe (Belgium, France, Germany, Italy, Netherlands, Spain, Ukraine), and the Middle East (Israel, Lebanon). Countries were classified with World Bank criteria as low-income (Nigeria), lower-middle-income (China, Colombia, South Africa, Ukraine), higher middle-income (Lebanon, Mexico), and high-income. The coordinated surveys on emotional mental health disorders, their severity, and treatments were implemented in the aforementioned countries. These surveys assessed the frequency, types, and adequacy of mental health service use in 17 countries in which WMH surveys are complete.
=== Emergency approvals (EUA) === Emergency Use Authorization (EUA) is a mechanism that was created to facilitate the availability and use of medical countermeasures, including vaccines and personal protective equipment, during public health emergencies such as the Zika virus epidemic, the Ebola virus epidemic and the COVID-19 pandemic.
== History == Polystyrene was discovered in 1839 by Eduard Simon, an apothecary from Berlin. From storax, the resin of the Oriental sweetgum tree Liquidambar orientalis, he distilled an oily substance that he named styrol, now called styrene. Several days later, Simon found that it had thickened into a jelly, now known to have been a polymer, that he dubbed styrol oxide ("Styroloxyd") because he presumed that it had resulted from oxidation (styrene oxide is a distinct compound). By 1845 the Jamaican-born chemist John Buddle Blyth and the German chemist August Wilhelm von Hofmann showed that the same transformation of styrol took place in the absence of oxygen. They called the product "meta styrol"; analysis showed that it was chemically identical to Simon's Styroloxyd. In 1866 Marcellin Berthelot correctly identified the formation of meta styrol/Styroloxyd from styrol as a polymerisation process. About 80 years later it was realized that heating of styrol starts a chain reaction that produces macromolecules, following the thesis of German organic chemist Hermann Staudinger (1881–1965). This eventually led to the substance's receiving its present name, polystyrene. The company I. G. Farben began manufacturing polystyrene in Ludwigshafen about 1931, hoping it would be a suitable replacement for die-cast zinc in many applications. Success was achieved when they developed a reactor vessel that extruded polystyrene through a heated tube and cutter, producing polystyrene in pellet form.
Sources: en.wikipedia.org
Matrix metalloproteinase-9 (MMP-9), also known as 92 kDa type IV collagenase, 92 kDa gelatinase or gelatinase B (GELB), is a matrixin, a class of enzymes that belong to the zinc-metalloproteinases family involved in the degradation of the extracellular matrix. In humans the MMP9 gene encodes for a signal peptide, a propeptide, a catalytic domain with inserted three repeats of fibronectin type II domain followed by a C-terminal hemopexin-like domain.
=== Anxiety disorders === Anxiety associated with depression is responsive to alprazolam. Clinical studies have shown that the effectiveness is limited to four months for anxiety disorders. However, the research into antidepressant properties of alprazolam is poor and has only assessed its short-term effects against depression. In one study, some long term, high-dosage users of alprazolam developed reversible depression. In the US, alprazolam is indicated for the treatment of generalized anxiety disorder and panic disorder with or without agoraphobia. In the UK, alprazolam is indicated for short-term symptomatic treatment of anxiety in adults.
== Medical uses == Terlipressin is indicated to improve kidney function in adults with hepatorenal syndrome with rapid reduction in kidney function. Indications for use include norepinephrine-resistant septic shock although, 2021 Surviving Sepsis Guidelines recommend against its use for adults with septic shock and hepatorenal syndrome. In addition, it is used to treat bleeding esophageal varices.
There were attempts to achieve friendly rapprochement between the Chilean regime and the Bolivian dictatorship of Hugo Banzer Suárez, to find a solution to Bolivia's landlocked nature, to ensure its neutrality, or even win its support from this country, in case there was a war against Peru. Through the Charaña Agreement, signed on February 8, 1975, both countries reestablished their diplomatic relations, interrupted since 1962. However, the agreement failed to advance due to additional demands from Peru, now under the command of the dictator Francisco Morales Bermúdez, since its territorial interests of Peru were intentionally violated. Instead of this agreement in its original version, Peru proposed that the territory be administered simultaneously by the three countries, however, both Chile and Bolivia refused to accept this complicated agreement, so Banzer again decided to break relations with Chile on March 17, 1978. On another occasion, the Peruvian Intelligence service obtained information that the Pinochet government was preparing a threat of war with Peru, as a way to end the internal problems of his regime. In 1976, the possibility of launching a preventive war against Peru was even evaluated, according to a dialogue he held that year with the then US Secretary of State, Henry Kissinger, during the meeting of the General Assembly of the Organization of American States in Chile during that year. However, Kissinger made it clear that the position of the United States would depend on who started the conflict.
Sources: en.wikipedia.org
Removing water reduces hydrolytic and some oxidative degradation. Powder forms are generally more stable for long-term storage than solutions. Stability still depends on peptide sequence, residual moisture, and container conditions.
Freezing slows most chemical reactions, but it can also concentrate solutes and promote aggregation during freezing or thawing. Repeated freeze-thaw cycles are often more damaging than constant cold storage. Some peptides require specific buffers or additives to remain soluble.
pH affects charge, solubility, and the reactivity of amino acid side chains. It can influence deamidation, oxidation, and aggregation pathways. The best pH is peptide-specific and is usually identified through stability testing.
Dividing a stock into single-use portions usually reduces multiple thawing and refreezing events and lowers contamination risk. It also allows a needed amount to be removed without warming the entire supply.